INTRODUCTION – HOW TO USE THIS MANUAL
IN–1
IN
HOW TO USE THIS MANUAL
GENERAL INFORMATION
1. GENERAL DESCRIPTION
(a) This manual
is written in accordance with SAE
J200
8.
(1) Diagnosis
(2) Removing / Installing, Replacing, Disassembling
/ Reassembling, Checking and Adjusting
(3) Final Inspection
(b) The following procedures are omitted from this
manual. However, these procedures must be
performed.
(1) Use a jack or lift to perform operations.
(2) Clean all removed parts.
(3) Perform a visual check.
2. INDEX
(a) An alphabetical INDEX section is provided at t
he
end o
f the manual as a reference to help you find
the item to be repaired.
3. PREPARATION
(a) Use of Special Service Tools (SST) and S
pecial
Service Materials (SSM) ma
y be required,
depending on the repair procedure. Be sure to use
SST and SSM when they are required and follow
the working procedures properly. A list of SST and
SSM is in the "Preparation" section of this manual.
4. REPAIR PROCEDURES
(a) A component illustration is placed under the
title
wh
ere necessary.
IN–2
INTRODUCTION – HOW TO USE THIS MANUAL
IN
(b) Non-reusable parts, grease application areas,
precoated parts and torque specifications are noted
in the component illustrations.
The following illustration is an example.
(c) Torque specifications, grease application areas and
non-reusable parts are emphasized in the
procedures.
HINT:
There are cases where such information can only
be explained by using an illustration. In these cases,
torque, oil and other information are described in the
illustration.
(d) Only items with key points are described in the text.
What to do and other details are explained using
illustrations next to the text. Both the text and
illustrations are accompanied by standard values
and notices.
(e) Illustrations of similar vehicle models are sometimes
used. In these cases, minor details may be different
from the actual vehicle.
(f) Procedures are presented in a step-by-step format.
5. SERVICE SPECIFICATIONS
(a) SPECIFICATIONS are presented in boldface text
throughout the manual. The specifications are also
found in the "Service Specifications" section for
reference.
Filter Cap
Float
Reservoir Tank
Slotted Spring Pin
Cylinder
Piston
Push Rod
Snap Ring
Boot
Lock Nut
Clevis
Clip
Clevis Pin
Washer
: Specified torqueN*m (kgf*cm, ft.*lbf)
Non-reusable part
GASKET
Grommet
12 (120, 9)
15 (155, 11)
Example:
D100720E01
Illustration What to do and where to do it
Task heading What work will be performed
Explanation text • How to perform the task
• Information such as specifications and warnings, which are written
in boldface text
INTRODUCTION – HOW TO USE THIS MANUAL
IN–3
IN
6. TERM DEFINITIONS
7. INTERNATIONAL SYSTEM OF UNITS
(a) The units used in this manual comply with the
International System of Units (SI) standard. Units
from the metric system and English system are also
provided.
Example:
Torque: 30 N*m (310 kgf*cm, 22 ft.*lbf)
CAUTION Possibility of injury to you or other people.
NOTICE Possibility of damage to components being repaired.
HINT Provides additional information to help you perform repairs.